Boley Q812 Mode D'emploi page 4

Start up
Place 1 x LR6 AA (1.5 V) Alkaline battery in the
correct position in the battery compartment of the
movement (Taking care to observe correct polarity
direction + –).
Release the transport lock of the pendulum,
pressing it lightly to the right where necessary.
Set the correct time using the hand set knob on the
back of the movement.
Melody selection
This movement has a choice of the traditional
Westminster chimes in quarter-hour rhythm with
counting of the full hour or the Bim-Bam gong every
half an hour with corresponding hourly chime.
The chosen melody is selected using the selector
switch (WM or BB).
The melody sounds for the first time after reaching
the full hour. The selected melody and 1 x the hour-
ly gong are played, irrespective of the actual time
6
set. On the subsequent hours the hourly gong is
added on accordingly.
After start up the movement synchronises itself for
the first time on passing the one o'clock position,
after which the hourly chimes are sounded in the
correct number.
Here it should be noted that initial synchronisation
following start up corresponds to the one o'clock
position.
When switching the melody from Westminster to
Bim-Bam gong or vice versa the requested signal
is sounded at the next full hour.
If the melody is switched off during the course of a
melody being played, the melody being played is
not interrupted.
Night setback
In addition, the movement also has a night setback
function in which the melody is played at reduced
volume.
Where night setback is activated the melody is
played at reduced volume between 22.15 and 6.45.
7