Table des Matières
Publicité
Maintenance of your Mouse
• You may clean the surface of the Mouse with a soft damp cloth.
• Do not use any harsh or abrasive cleaners.
• Before using any chemical cleaners, please test the results on the bottom of the device.
International Standards and Safety
This optical device complies with international Standard IEC 825-1: 1993. Class 1 LED product. CAUTION: Use of controls or
adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This
optical device has no serviceable parts. User observable light is 15 microwatts in normal operation. This device is rated as a
commercial product for operation at 32° F (0° C) to 104° F (40° C).
UL Testing
Your product is UL tested and should only be used with other UL listed devices.
Customer Service
If you need additional help with you product, contact Labtec at (702)269.3612 or on the web at: www.labtec.com
FCC Compliance and Advisory Statement.
This hardware device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this
device may not cause harmful interference, and 2) this device must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed or used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: 1) reorient or relocate the receiving
antenna; 2) increase the separation between the equipment and the receiver; 3) connect the equipment to an outlet on a
circuit different from that to which the receiver is connected; 4) consult the dealer or an experienced radio/TV technician for
help. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. Where shielded interface cables have been p
p
Canadian DOC Statement
This digital device does not exceed the Class B limits for radio noise emissions from dig ital apparatus specified in the
interference-causing equipment standard entitled "Digital Apparatus," I CES-003 of the Department of Communications. This
device complies with RSS-210 of Industry and Science Canada. Operation is subject to the following two conditions: 1) this
device may not cause interference, and 2) this device must accept any interference, including interference that may cause
undesired operation of the device Limited Product Warranty.
English
2
Publicité
Table des Matières
