YBA Signature CD Player Livret D'utilisation page 6

Signature CD Player
Discovering your Signature CD: Rear view
1
RCA AUDIO OUTPUT: Connect your amplifier (or any other suitable device such as powered speakers,
1
receiver, etc) to the RCA outputs of your Signature CD.
Balanced Audio output: This is a higher quality output which can reject noise and interference in the
2
cable when used with equipment with balanced inputs. XLR connectors should be wired as follows:
Pin 1 - Ground; Pin 2 - Hot (in-phase); Pin 3 - Cold (phase-inverted).
Coaxial digital output: The digital coaxial output allows you to connect an external DAC or a digital
3
recorder.
4 Power inlet: Connect the mains cable supplied with your Signature CD player to the inlet on the rear
panel. Be sure your Signature CD switch is in OFF position before plugging or unplugging the mains
cable.
ON/OFF switch: Use this button to switch ON or switch OFF your signature CD player.
5
Page 6
2 1 2
www.ybahifi.com
3 4 5