ECG FS 40N Mode D'emploi page 29

Make sure that the power cable or extension cord can not be
accidentally pulled out of the socket during operation.
Use the handle to carry the appliance.
Warning: To prevent overheating, do not cover the fan.
DANGER FOR CHILDREN: Children must not play with the packaging
INSTALLATION
1. Remove each part
packages. If the front and back
screens are connected, separate
these.
2. Remove the base and parts of the
stand from the box and loosen
the 4 attachment screws. Attach
the stand to the base using the
attachment screws.
3. Dismantle the four position screws
on the motor, place the back screen
against the four holes on the motor
(handle facing upward), insert the
four position screws into the holes
and tighten these.
4. Loosen the nut screw on the
propeller, place the propeller on
the motor shaft and secure by
tightening the screw. Make sure the
propeller does not interfere with
the screen.
5. Install the front screen on to the
back screen. Tighten the screw and
nut, secure the retaining clips.
HEAT PROTECTION
Heat protection is activated if an
actuating unit is overloaded. The fan
switches off automatically. In this case, refer to a professional service centre.
USE
The fan has 3 speeds, its rotating head ensures smooth rotation. It is quiet, with a low energy consumption,
reliable and safe and at the same time, ensures effective air circulation.
The switch is integrated in the speed control on the head of the fan.
0 - Fan is off.
1 - Fan is running at low speed.
Do not immerse in water!
material. Do not let children play with the
plastic bags. Risk of suffocation.
from the
Nut
Front
screw
screen
Propeller
Position
Back
screw screen
Connector
Spring
Base
Rotation
control
GB
Speed
control
Motor
Supply
feed
Stand
29