Hama 00053325 Mode D'emploi page 3

Note - COM port settings
To change the COM port settings, double-click the
aforementioned entry in the Device Manager and
select the Port Settings tab.
5.3 Installation on Mac OS X 10.8.x, 10.9.x and
10.10.x
A suitable driver is usually included with the current Apple
operating systems; you will not normally have to install the
driver manually. However, if you are experiencing problems
with the default driver, you can also use the driver on the
CD-ROM. The driver is located in the "Driver" -> " „Mac"
directory." on the CD.
• Start your operating system and connect the USB-to-serial
converter to a free USB port.
• Your system then recognizes and installs the cable.
5.4 Installation on Linux
Since kernel release 2.6.34, the appropriate drivers are
already included. You do not have to compile the driver.
Unfortunately, we do not offer support for Linux. If you are
experiencing problems with the USB-to-serial converter, we
recommend that you find an Internet forum that discusses
your Linux distribution and ask about possible solutions
there.
6. Care and Maintenance
• Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
3