Switching Off The Blower Unit; Care, Maintenance And Repair; Replacing Intake Filter - GEHEIT ABAC SG 90 E Instructions De Montage

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

7

Switching off the Blower Unit

The pushbutton switch on the Blower unit should be switched off using
your thumb when spraying has been completed. Only then should the unit
be disconnected from the mains. When work has finished, coil connection
cable as shown in figure 1.
8

Care, Maintenance and Repair

Always switch oft your Blower Unit, and disconnect
from mains, before carrying out any repair and main-
tenance work.
Do not use any solvents or aggressive fluids to clean
the fan cage.
Repair and maintenance work, or the replacement of
the power cable, should only be carried out by author-
ized specialist firms or by us. Addresses of authorized
firms can be obtained from us or from your dealer.
Excepting filter maintenance (see item 8.1 ), your SG 90 E Blower Unit
does not require any customer servicing to be carried out.
8.1

Replacing Intake Filter

Switch oft blower, disconnect from mains and wait un-
til motor is stationary before opening filter cap.
Always replace the intake filter if it is dirty. Do not at-
tempt to clean it.
The intake filter should always be checked before spraying and replaced
as shown in figure 7 if it is dirty. This ensures that the air flowing through
the gun is always clean.
Turn to the left to open filter cap, and completely through to the right to
close.
29

Publicité

Table des Matières
loading

Table des Matières