VONROC GG502DC Traduction De La Notice Originale page 5

a) The appliance is not to be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of expe­
rience and knowledge, unless they have been
given supervision or instruction
b) Children being supervised not to play with the
appliance
c) Do not recharge non-rechargeable batteries!
d) During charging, batteries must be placed in a
well ventilated area!
e) Integrated batteries may only be removed
for disposal by qualified personnel. Opening
the housing shell can destroy the power tool.
To remove the battery from the power tool,
press the On/Off switch (6) until the battery is
fully discharged. Unscrew the screws on the
housing and remove the housing shell in order
to remove the battery. To prevent a short circuit,
disconnect the connectors on the battery one
at a time and then isolate the poles. Even when
fully discharged, the battery still contains a
residual capacity, which can be released in case
of a short circuit.
RESIDUAL RISKS
Even when the power tool is used as prescribed it
is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with
the power tool's construction and design:
a) Health defects resulting from vibration emission
if the power tool is being used over longer
period of time or not adequately managed and
properly maintained.
b) Injuries and damage to property to due to bro-
ken accessories that are suddenly dashed.
2. MACHINE INFORMATION
Intended use
The glue gun is intended for the quick gluing of
clean, dry and grease-free materials with hot-melt
adhesives. The tool is intended for hobby use at
home only.
WWW.VONROC.COM
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Battery
Built in charger
Heating time
Temperature
Diameter glue stick
Charging time
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Trigger
2. Base
3. Nozzle
4. Heat up LED indicator
5. On/off switch
6. Glue gun charging contacts
7. Battery and charger LED indicator
8. Base charging contacts
9. Drip tray
10. Micro USB charging port
11. Glue sticks
12. Charger cable
3. OPERATION
The machine must be charged before first
use.Charging the device (Fig. B-C)* Plug the
charger cable (12) (included) into an
adapter (not included).* Plug the charger
cable (12) in the micro USB charging port
(10). See figure B
• Place the glue gun in to the base and make sure
the glue gun charging contacts (6) and base
charging contacts (8) are connected. See Fig. C.
• The charger LED indicator (7) will lighten up and
show the charging status.
NOTE: Be sure that the metal contacts (6+8) in the
glue gun and base are clean before charging.
EN
GG502DC / S_
GG502DC
4V
1500mAh Li-Ion
5V USB
Max. 25 sec
170°C - Automatic shut
off 6.5 min
7 mm
app. 3 hours
5