Specifications; Air Filter; About The Air Filter; Replacing The Air Filter - Sony LMP-H400 Mode D'emploi

Specifications

285.6 mm × 142.1 mm ×
Dimensions
141.1 mm
× 5
1
(11 /
4
(w/h/d)
Mass 2.9 kg (6 lb 6 oz)
Supplied accessories
Operating Instructions (1)
× 5
5 5
/ / inches)
8 8

Air Filter

About the Air Filter

Whenever you replace the lamp, be sure to
replace the air filter with a new one
immediately.

Replacing the Air Filter

Note
When removing the air filter from the
projector, be careful that no dust or object gets
into the inside of the projector.
The illustrations below show the case of
replacing the air filter with the projector
installed on the floor or desk.
Pay special attention to replacing the air
filter when the projector is installed on
the ceiling.
1
Turn the power off and unplug
the power cord.
2
Place a protective sheet (cloth)
beneath the projector and turn the
projector over.
3
Remove the filter holder.
When the air filter cover has been attached
onto the projector because it is installed on
the ceiling, remove this air filter cover
before removing the filter holder.
5
GB
Air Filter