Troubleshooting - Cata CTR-30-M Instructions Pour L'installation, L'utilisation, L'entretien

!
Non-professionals are not allowed to disassemble the thermal switch to reset.
Please contact professionals to maintain. Otherwise our company will not take
responsibility if any quality accident happens because of this.

6. TROUBLESHOOTING

Failures
The heating indicator
light is off.
No water coming out
of the hot water outlet.
The water temperature
is too high.
Water leak.
Parts illustrated in this use and care manual are indicative only, parts provided with the
product may differ with illustrations.This product is intended for household use only.
Specifications are subject to change without notice.
Manual reset button
WARNING
Reasons
Failures of the temperature
controller.
1. The running water supply
is cut off.
2. The hydraulic pressure is
too low.
3. The inlet valve of running
water is not open.
Failures of the temperature
control system.
Seal problem of the joint of
each pipe.
NOTE
8
Treatment
Contact Assistance Service
helping for repair.
1. Wait for restoration of
running water supply.
2. Use the heater again
when the hydraulic
pressure is increased.
3. Open the inlet valve of
running water.
Contact Assistance
service helping for repair.
Seal up the joints.
(Fig.6)