PCM GSC-1113 Mode D'emploi page 2

English
1. To fix the tool holder to the machine,
introduce the shank and use the pin
for the positioning.
Then tighten the 2 screws of
fixations (Important, watch that the
screws have the same strength of
tightening).
Finally, add the M8 screw and
washer and tighten.
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSC-1113
3. During the mounting or the dismounting
of your tools, block the broach on flats
planned for that purpose, using an
adapted wrench.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
GSC-1113 1- Mode
BT
Validation : 13.03.2013
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: office@pcm.ch
Document :
d'emploi 1-
Page : 2 de 4