Usage Instructions - JOOLA Noctis 11105 Mode D'emploi

USAGE INSTRUCTIONS

Unfolding the Table:
When unfolding the table, the first step is to lock the casters. Then, take caution so that all areas
around you are clear. Please remember, the table is very heavy. If you are worried that it may be too
heavy, it is recommended that at least two people unfold the table. To unfold the table, push on the
lock to release the table from the storage position. After unlocking the table, slowly lower the table half
down. Do the same for the other half. Check to make sure that the locking hinge bar attached to each
leg of the table is straight (locked). Then install the net and post set, and enjoy the table tennis table.
Folding the Table:
To fold the table into storage position, the first step is to lock the casters. Next, ensure that the net and
post set have been removed from the table. Failure to do so could cause damage to the table when
trying to fold the table with the net and post set still attached. Then, unlock (by bending) the locking
hinge bar to enable the H-bar to be stored against the bottom of the table surface. Please remember
that the table is very heavy. Ensure that you have enough ceiling height to raise the table half. If you
are worried that the table will be too heavy for you to lift, it is recommended that at least two people
fold the table. Raise the table half to the vertical position until you hear a loud clicking noise and make
sure that the lock is fully engaged.
Playback Position:
Playback position is achieved by unfolding one half of the table and folding the other half. Make sure
that the locks of the folded half are fully engaged. Always use the locking casters and place them in
lock position when the table is in playback position for added safety.
Leveling:
The table comes with leveling feet. Spin the leveling feet to adjust the height and make the table level.
Using the locking casters:
When the table is in storage position, or in play position, please remember to always lock the casters
for added safety.
Using the magnetic scorer:
Apply to any metal part of the table.
Do not use on the table surface as scratching may occur.