Contrôle - Seifert 862504001 Manuel D'utilisation

The display is used to
Control / Alarm Set Point Settings
Temperature Readings
Alarm Readings
The main menu will display the following by default
TEMP READINGS: temperature readings and alarm display
TEMP SETPOINTS: to change set points by pressing UP or DOWN button and SET to choose an option
TEMP READINGS showing the temperature readings and any alarms. Each alarm will be shown by flashing
every few seconds.
The example is showing a communication loss with the inverter alarm.
Press MENU to return to the main menu.
List of possible alarms
ALARM COMPRESSOR
ALARM INT BLOWER
ALARM AMB BLOWER
ALARM HIGH TEMP
ALARM INV COMMS
ALARM SENS FAIL
ALARM LOW TEMP
ALARM CONT COMMS
WARNG COMPRESSOR
WARNG INT BLOWER
WARNG AMB BLOWER
DOOR CONTACT
In case the inverter issues an alarm on any of the motors, the system switches off the respective motor and
Revisions Nr. 1-6 - 10.08.2021
8. Contrôle
High Temperature Alarm
No Communication with Inverter Alarm
Temperature Sensor Fail Alarm
Low Temperature Alarm
No Communication with Main Controller Alarm
Door Contact Open
Doc. nr. 99862504001 12 / 20