Direct Healthcare Group SystemRoMedic Bure Rise & Go Manuel D'utilisation page 10

5. Raising/Lowering the Frame
The desired height is adjusted with Arrow <UP> or Arrow <DOWN>.
Adjust bottom frame using <WIDER> arrow or <NARROWER> arrow.
Handset from Plus also have charge indicator / battery (low, medium, high)
and Service indicator (see further under "18 Hand Control Plus").
6. Adjusting the Handles
To adjust handles to the desired position; undo knob, adjust handle, tighten
knob.
7. Left and Right Adjustment of Armrests
The armrests can be adjusted sideways for optimal support: the
whole arm can be moved in or out and locked with the knob.
8. Locking/Unlocking Castors
Depress the foot brake to set it and lock the castor. To
unlock, press down on the protruding part of the brake.
9. Adjusting the Shin Supports
a - knob for height adjustment.
b - knob for locking shin supports in forward position
(when not in use).Supportsit.
10. Control Box Wiring
Remove the control box cover to make the connections as described
below. Use a screwdriver or similar; refer to the special labels on the
control box.
NOTE: Make sure that plugs are connected to the correct sockets
otherwise the actuators can be damaged.
1. Socket for the height adjustment actuator.
2. Socket for the width adjustment actuator.
3. Hand control socket.
4. Battery terminal socket.
5. Plug socket (NOTE: Plugs must ALWAYS be connected to the control
box for IP classification to be valid).
10
a
b
1 2
3
4
5
I F U