Publicité
Les langues disponibles
Les langues disponibles
NOTE: Read the entire instruction manual before you start installation and assembly.
�WARNING
• Do not begin the installation until you have read and understood all the instructions and
warnings contained in this installation sheet. If you have any questions regarding any of
the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as specified in this
manual. lmproper installation of this product may cause damage or serious injury.
• This product should only be installed by someone with good mechanical ability who has
basic building experience and fully understands this manual.
• Make sure that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
• Always use an assistant or mechanical lifting equipment to safely lift and position the
equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage to the
items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could lead to
product failure and persona! injury.
Required for Installation
Component Checklist
IMPORTANT:
Ensure that you have received ail parts according to the component checklist prior to installation.
If any parts are missing or faulty, contact your place of purchase for a replacement.
c::::1
=-
�= =
A (x1)
�
support bracket
support bracket
M8x12
E (x1)
F (x1)
G (x16)
1
IFJl
equipment shelf
sliding nut
connecting plate
B (x1)
C (x20)
D (x2)
c::::::=
M8x10
M6x12
end cap
cable clip
H (x4)
1 (x4)
J (x2)
K (x2)
1. Attach Connecting Plate to the Column
lnsert 8 sliding nuts(C) into the slots on both sides of each
column(not included) as shown in Figure Top View.
li)
ll!l
• Align the mounting holes on sliding nuts to the holes found on the connecting
plate as shown in the Top View illustration below. Attach the Connecting Plate(D)
to the Column(not included). You will not tighten the Screws(G) in this step.
• Use the tape measure(not included) to set the distance between the bottom of
connecting plates on the column. Make sure the distance is over 570mm(22.4").
Once set, tighten the Screws(G).
Note: Leave at least 10mm gap at the top of the column for the end cap.
2. Attach Column to the Mounting Rail
1. Lay Mounting Rails(A) on the floor with the two slots side facing upward.
2. lnsert 8 Sliding Nuts(C) into 2 slots on each mounting rail as shown in Figure
Side View and position the nuts centrally on the rails.
,-
\
TopView
C
1
1
1
1
�
1
1
1
----------------------------�
SideView
1
1
1
Publicité
