Osc 1 Menu (Hypersaw Oscillator); Osc 1 Menu (Wavetable Oscillator); Osc 1 Menu (Formant Complex Oscillator) - Access Virus TI Snow Guide De Démarrage Rapide

26 QUICKSTART MANUAL

OSC 1 Menu (HyperSaw Oscillator)

For this walkthrough dial up the patch "Tutorial 2" (RAM8 8-2). This is a basic patch using the HyperSaw
oscillator.
Soft Knob Parameter
#1 Density
#2 Local Detune
#3 Osc Balance

OSC 1 Menu (Wavetable Oscillator)

For this walkthrough dial up the patch "Tutorial 3" (RAM8 8-3). This is a basic patch using the Wavetable
oscillator.
Soft Knob Parameter
#1 Index
#2 Interpolation
#3 Osc Balance

OSC 1 Menu (Formant Complex Oscillator)

For this walkthrough dial up the patch "Tutorial 4" (RAM8 8-4). This is a basic patch using the Formant Com-
plex oscillator.
Meaning
Use Density to determine the number of saws per voice - anything from 1 up
to 9!
Use Local Detune to determine the level of detuning between the saws. At
zero, the saws will be in perfect tune, and phase-cancellation will occur as
a result (this is normally undesirable) and at the maximum value of 127, the
saws will be detuned by a semitone.
This determines the balance between the outputs of Oscillator 1 and
Oscillator 2. At centre position (default), you will hear both oscillators. Adjust
towards -64 to hear just the output of Oscillator 1, and towards +63 to hear
just the output of Oscillator 2.
Meaning
Adjust Index to sweep through the wavetable.
Use Interpolation to determine how smoothly you can sweep through the
wavetable. Try setting this at 127, and have another play with Index on
Value 1. Moderate values can yield a nice, 'bumpy' effect.
This determines the balance between the outputs of Oscillator 1 and
Oscillator 2. At centre position (default), you will hear both oscillators. Adjust
towards -64 to hear just the output of Oscillator 1, and towards +63 to hear
just the output of Oscillator 2.