Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remove the cable tie and unravel the cordset before operation.
The fan and motor assembly are attached to a 2-position ratchet. Tilt up or
down until the assembly clicks into the desired position (Fig.6).
(Fig.6)
CARE AND CLEANING
•
Always disconnect electrical appliances before cleaning them.
•
Never spray with liquids or submerge the mist fan in water or any other
liquid.
•
Do not fill with water over 40
deformation.
•
Pour out water from sink & tank when temperature below 0
away from freezing to avoid component damaged.
•
Do not fill water into handles directly.
•
Water Sink Cleaning: If sink with dusty or dirty material,put detergent onto
soft cloth to clean the dirty place, then clean with water.
•
First cut power off, take out water tank then pull mist tube appropriately.
Clean it if it's dirty. Use clean water to wash mist control box.
(Fig.7)
Clutch
O
C in tank and sink to avoid discoloration or
O
C to keep water
4
47
Publicité
Table des Matières
