Operation - Lupine Blika R 4/X 4 Manuel D'utilisation

Operation

Initialization & voltage display:
After connecting the lamp to the battery, the software runs a selftest. The lamp itself as well as the
red and blue LEDs in the switch light up once. The
LEDs, as follows:
 The blue LED fl ashes once for each volt; and then
 the red LED fl ashes once for each 1/10 of a volt.
Example: The LED fl ashes seven times blue
and fi ve times red = battery voltage is 7.5 V.
Control concept:
Operation via the buttons of the lamphead: (Switch on by short push)
Top button: Operation of the main programs (see page 9)
Lower button: Operation of the special LEDs (Redlight, Greenlight, Spotlight, Diff uselight)
Note: An almost free assignment of the buttons is only possible through the app.
Control via the remote control:
Two operating concepts are available.
1. Operation of the lamp analogous the buttons of the lamphead
Blue button on remote = Top button of lamphead
Green button on remote = Lower button of lamphead
2. Blue to increase the output, Green to lower the output
Switching between operating concepts 1 and 2: Press and hold the green pushbutton of the
remote control until the blue and green LEDs fl ash alternately, then let the button go.
Switching:
Each quick push of the button switches through the dim levels.
Turn off :
To turn off the lamp, keep the button pressed.
22 Blika R
battery voltage is indicated by the blue and red
Interpreting the voltage display:
more than 8.0 V battery is fully charged

7.1 to 7.8 V battery needs charging

6.5 to 7 V battery is not ready for use

The switch on the lamphead as well as the Bluetooth remote are equipped with a
RGB-LED to show informations about the dim level and the remaining battery
capacity.
blue LED lighting: Lamp is on high beam.
green LED lighting: Lamp is on a lower beam.
red LED lighting: 1. Battery Warning, low capacity remaining.
The red LED is lighting.
You can adjust the timing of the battery warning,
see progamming on next page.
red LED fl ashing + 2. Battery Warning, very low capacity remaining.
light fl ashing ones: The red LED is fl ashing and Blika fl ashing ones, too.
blue + red LED Warning!
fl ashing in turn + The red and blue LED fl ashing in turn, the lamp fl ashes 30
light fl ashing 5 times: times.
blue + red LED After switching the light on again, reserve power at a low beam
fl ashing in turn: is available.
light will be switched off automatically. So slow down!
Note:
depends on the total battery capacity, the ambient tempera-
ture and the age of the battery.
Meaning of LED colors
Stop immediately! The light will be switched off .
When reserve power is completely discharged, the
The burn time remaining after the red LED is illuminated
Blika R 23