Adjusting The Volume; Indications On The Display - Monacor ATS-60R Mode D'emploi

The reception symbol
the transmitter is switched off. If it does, interfer-
ence or signals from other transmitters are being
received. In this case, use a different channel.
3) To operate multiple wireless ATS-60 systems at the
same time, set a different transmission channel for
each separate system.
Six simultaneous voice transmissions are sup-
ported: Select two channels from the range 1 – 16
and four channels from the range 17 – 24 (e. g. chan-
nels 2, 14 and 17, 19, 21, 23).
4) Switch on the transmitter and set it to the trans-
mission channel of the receiver. The symbol
appear on the display of the receiver as soon as a
signal is being received.

4.2 Adjusting the volume

1) Use the control (2) on the receiver to adjust the
volume of the earphone.
CAUTION! Never adjust a very high volume. Per-
manent high volumes may damage your hearing.
2) Use the control (2) on the transmitter to adjust the
volume of the microphone in such a way that no
distortions occur. Then adjust the volume of the
earphone.

4.3 Indications on the display

Indication
on the receiver 
on the transmitter 
MHz
L H
/
...
5 Specifications
Transmission frequency / Transmission power / Range
823 – 832 MHz, CH01 – 16: ≤ 50 mW (EIRP) / approx. 300 m
863 – 865 MHz, CH17 – 24: . ≤ 10 mW (EIRP) / approx. 240 m
Microphone: . . . . . . . . . . . . Electrect microphone
Power supply: . . . . . . . . . . . Lithium-ion battery,
Dimensions: . . . . . . . . . . . . . 50 × 102 × 25 mm
Weight: . . . . . . . . . . . . . . . . 115 g
Subject to technical modification.
Function
× × Channel number
× × Transmission frequency
Transmission power 10 / 50 mW
×
(low/ high)
× × Buttons  and  are locked
× A signal is being received
× × Battery status full ... discharged
3.7 V/ 2400 mAh
must not appear when
will
9