- En cas de dysfonctionnement électrique ou autre, n'essayez pas de réparer
l'appareil, apportez-le à un service d'assistance technique agréé.
- Si le câble d'alimentation est endommagé, il doit être remplacé par le fabricant,
son service après-vente, des agents agréés ou un personnel doté d'une
qualification similaire, afin d'éviter toute situation dangereuse.
ASSISTANCE TECHNIQUE
- En cas de dysfonctionnement de l'appareil, veuillez contacter l'un de nos
services officiels, où vous serez dûment reçu. Toute réparation effectuée par des
personnes autres que nos services officiels entraîne l'annulation de la garantie.
EN - Egg Boiler
WARNING
- YOUR DEVICE IS PROTECTED BY A THIN PLASTIC LAYER WRAPPING
ITS CASING. PLEASE CARE TO REMOVE PLASTIC LAYER BEFORE
FIRST USING DEVICE.
- Please read these instructions carefully before using this product for the first
time. Please keep these instructions for future consults.
- Chose the place where the device will be working accordingly:
a) Do not place device near combustible materials or materials liable to be
deformed by heat. In case this is not possible, please cover the area with a
good heat insulating, non-combustible material.
b) Please chose a place that is as less damp as possible.
- Plug device into socket with voltage described in device type plate.
- Make sure device is plugged into electric circuit whose power is described by
type plate.
- This is a Class I device. Please plug device into socket with ground terminal.
- Please do not use this device with a chronometer or any other device that
turns it on automatically.
- Never use extension cords to increase cord length. Never use T-adapters.
- Switches and temperature regulators must be off every time device is plugged
in or plugged off.
- Do not turn device off by pulling the cord.
- Do not turn device on if the cord or plug are damaged or if device is not
working properly.
- Do not turn device on if the cord is coiled.
- Do not place device near water taps.
- Do not place device close to power sockets.
- Do not use device with wet hands.
- Always use device in vertical position.
- Do not leave device unattended while on, especially around children. Children
must not play with device. Cleaning and maintenance must not be made by
unsupervised children.
8
- Before cleaning device, please confirm if device is turned off and has cooled
down.
- Do not immerse device in water or any other liquid.
- Power cord repair and replacement must be performed by authorised
technical services only.
SAFETY
- Device must be connected to properly installed and protected power source
that is adequate for device power.
- Please prevent cord from touching any heated part of device.
- Device reaches high temperatures when operating, so please handle device
carefully.
WARNING: In case of accidental water spill, disconnect device from power
source immediately and dry it properly before using it again.
CLEANING AND MAINTENANCE
- Clean device on a regular basis.
- Disconnect device from power grid by unplugging device and let it cool down
before cleaning.
- Use damp cloth to clean device control area and power cord. Never use
abrasive products.
Use a damp cloth only. Never use water jets for cleaning.
- Dry device with soft cloth.
USE INSTRUCTIONS
Fill water tank (2) and make sure to observe a minimum water amount
between 25 mm from tank bottom to half the tank (about 75 mm). Adequate
water level will depend on the number of eggs to boil.
- Place desired number of eggs into provided egg holder (4) up to a maximum
of 6 eggs.
Important note: water level must never exceed 2/3 of tank capacity (eggs
included). Removing excess water may lead to burns!
- Turn device on by using switch (6) and select desired temperature using
regulating thermostat (8). Power indicator (7) will turn on.
- After completing the operation, turn off device by using general switch (6).
IMPORTANT NOTE: Please let device cool down and disconnect device from
power grid by pulling the plug off the socket before removing used water.
This device is for boiling/heating eggs only. Do not use device for other
purposes.
MALFUNCTIONS
- In case of electrical malfunction, do not try to repair device by yourself.
Please take device to authorised Technical Support Service.
- Damaged power cords must be replaced by manufacturer, post-sales service,
authorised agents or qualified personnel only in order to avoid dangerous
situations.
9