Abus HomeTec Pro CFT3000 Mode D'emploi page 20

f. MENU DRIVE
select the required drive.
Overview
Rename
Without code
Automatic
Touch control
Latch time
Latch power
Signal
20
HomeTec_Pro_Tastatur_160729_V02 PL+HU.indd 20
Door 1, Door 2, Door 3. Note: if you are using multiple drives on different doors,
Driving cycles: shows how many times the latch was pulled, unlocked
or locked. Lock: shows the lock position (locked or unlocked). The
number in the brackets shows the installed software version number.
You can assign names when using multiple drives (e.g. front door,
garage etc.). Assignment of the characters see
character with
Cancel with
Lock without code. Note: If the menu option "lock without code" is
selected, you can lock the door simply by pressing
active.
Automatic locking
Inactive, active.
If this function is enabled, you can set a time from - to,
in which the drive locks automatically. [hh:mm]
Note: In the set time it is regularly (approx. every 15 min.) queried whether
the drive is locked. This feature leads to higher energy consumption.
cancel
Operating the drive keys
Active: all drive keys can be operated.
Operating keys: both arrow keys are deactivated on the drive
Inactive: all arrow keys are deactivated on the drive.
cancel
time for which the latch is stopped when opening the door.
Can be selected with
cancel
Medium, Low, High. (Recommendation: for optimal service life of
the drive and key, select the "Medium"/"Low" setting.)
cancel
Setting the acoustic in the drive
Latch: signal only sounds when pulling back the latch
Locked: signal only sounds when locked
Each end position: signal sounds when opened or locked
Inactive: no signal sounds for any position
Start of drive: signal sounds at the start of the opening or locking drive
cancel
. Save the name with 3 seconds
.
cancel confirm
confirm
confirm
from 1 to 20 seconds.
confirm
confirm
confirm
e. Continue to next
5.3
.
. Inactive,
-
0 9
27.09.16 15:40