Trebs 49300 Mode D'emploi page 6

OPERATIONS INSTRUCTIONS
Attention
It is highly recommended to use clean distilled or descaled water.
The Trebs 49300 works through cold water vaporation. When using regular hard water, the mist could contain
small limescale particles which could affect the surface of furniture and floors around the Humidifier.
1. Open the top cover and add water into the water tank. The water tank should never exceed the MAX water
level. Using clean distilled or descaled water is highly recommended.
2. Put the top cover back in place and carefully place the water tank on top of the base unit.
3. Plug in the electrical power socket. After a couple of seconds the indicator light will light up for about
1 second, indicating the 49300 has entered stand by mode.
4. Press the button to activate the 49300, the default starting mode is low setting.
5. Pressing the mode repeatedly will switch between modes in the following cycle: Low -> Medium -> High -> Off
The current mode can be identified with the indicator lights being on.
WiFi signal indicator
Indicator light 2
Indicator light 1
Button
Mode Low:
Mode Medium:
Mode High:
Water level indicator light
When the 49300 is operational, the water indicator light can be turned on/ off manually by pressing and holding
the button for 2 seconds.
CLEANING THE 49300
Due to proper hygiene it is recommended to thoroughly clean the Trebs 49300 every 3 days.
Clean the 49300 thoroughly before storing the device for a longer period.
1. Turn off the 49300 and unplug the power cord.
2. Open the top cover and pour out the remaining water in the water tank and base unit.
3. Clean the base unit, water tank and top lid with a clean cloth.
Indicator 1
Indicator 2
Indicator 1 + 2
6