Applications; Break-In Period - RIDGID R0230 Manuel D'utilisation

OPERATION

APPLICATIONS

Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
You may use this product for the purposes listed below:
 Operating light- to medium-duty air-powered tools
 Operating air accessories such as air nozzles and
automotive tire inflators
INSTALLING/REMOVING BATTERY PACKS
See Figure 1, page 13.
NOTE: For best performance, install two fully-charged
battery packs before beginning operation. Minimum
recommended battery capacity is 4.0 Ah per battery pack.
 Make sure the air compressor is turned off.
 Insert each battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
CONNECTING/DISCONNECTING AIR HOSE
(HOSE NOT PROVIDED)
See Figure 2, page 13.
WARNING:
Never exceed the air tool's pressure rating as
recommended by the manufacturer. When using
this air compressor as an inflation device, always
follow the maximum inflation guidelines stated by
the manufacturer of the item being inflated.
 Make sure the air compressor is turned off and the battery
packs are not installed.
 Rotate pressure regulator knob fully in the counter-
clockwise direction so that the outlet pressure is at
zero (0) psi.
 Attach hose with quick connect air fitting to 1/4 in. quick
coupler on air compressor. Make sure to push the hose
adapter end fully into the coupler until the sleeve springs
forward to lock it in place.
To disconnect an air hose or an air tool:
 Confirm that the outlet pressure is at zero (0) psi.
 When disconnecting a hose from 1/4-in. quick coupler,
always firmly hold release end of hose.
 Pull back on the release sleeve on the 1/4-in. quick
coupler.
 With a firm grip, pull out the quick-connect air fitting that
is attached to the quick coupler.

BREAK-IN PERIOD

Before first use, install two fully charged 4.0 Ah battery packs.
Run the air compressor at zero tank pressure with the drain
valve fully open for 30 minutes or until both battery packs
are completely discharged, whichever happens first.
TURNING THE AIR COMPRESSOR ON/OFF
See Figure 3, page 14.
 Install the battery packs.
 Move the Auto On/Off switch to the AUTO ON (I) position
to power the compressor on.
 To turn the air compressor off, move the Auto On/Off
switch to the OFF (O) position.
NOTE: When the compressor is in the AUTO ON (I) position,
the air compressor will automatically turn back on when
the designated tank air pressure drops below the preset
pressure limit. It will also shut off again when the cut-off
pressure is reached.
WARNING:
Never exceed the air tool's pressure rating as
recommended by the manufacturer. When using
this air compressor as an inflation device, always
follow the maximum inflation guidelines stated by
the manufacturer of the item being inflated.
WARNING:
Always ensure the switch is in the OFF (O) position
and the regulator pressure gauge reads zero before
changing air tools or disconnecting the hose
from the air outlet. Failure to do so could result in
possible serious personal injury.
9 – English