Door Reversal - Samsung DV42H5400 Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6. Review the "Gas requirements" section on page 15.
Remove the pipe thread protective cap. Apply a pipe joint compound or about 1½ wraps of Teflon tape over
all threaded connections.
The pipe joint compound must be resistant to the actions of any liquefied petroleum gas.
Connect the gas supply to your dryer. An additional fitting is required to connect the 3/4" (1.9 cm) female
thread end of a flexible connector to the 3/8" (1 cm) male threaded end on the dryer.
Securely tighten the gas line fitting over the threads.
Turn on the gas supply.
Check all gas connections for leaks using a soap solution.
If bubbles appear, tighten the connections and recheck. DO NOT use an open flame to check for gas leaks.

Door reversal

1. Unplug the power cord.
2. Remove two door hinge screws.
3. Lift the door and remove it.
4. Remove two screws from the frame front.
5. Remove the two screws from the opposite side of the door hinge.
6. Remove the two screws from the holder lever.
7. Reassemble the two screws on the inside holes.
DV425000_DC68-03381A.indd 20
English - 20
2013-12-19
1:07:13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dv42h5200 sérieDv42h5000 série

Table des Matières