Installation Du Lavabo - Kohler K-2604 Guide D'installation Et D'entretien

Table des Matières

Publicité

5.
Install the Lavatory
Install the faucet (if applicable) and drain to the lavatory. Refer to the faucet and
drain manufacturer's installation instructions.
NOTICE: Siliconized acrylic caulk must be used to secure the lavatory to the vanity.
Do not use 100% silicone sealant, which will damage the finish of the vanity.
Run a 1/4" (6 mm) continuous bead of siliconized acrylic caulk around the top of
the vanity, as illustrated.
CAUTION: Risk of personal injury. Vitreous china lavatories are very heavy. Get
help lifting and aligning the lavatory.
NOTE: The lavatory is properly positioned when: (1) the back edge of the lavatory is
flush against the finished wall and (2) the overhang on the left, right, and front side
of the lavatory is equal on each side of the vanity.
With assistance, lift and properly position the lavatory on top of the vanity.
Immediately wipe away any excess caulk that contacts the vanity.
Run a 1/8" (3 mm) bead of siliconized acrylic caulk along the top edge of the
lavatory where the lavatory contacts the finished wall.

Installation du lavabo

Installer le robinet (si applicable) et le drain au lavabo. Se référer aux instructions
d'installation du fabricant du robinet et du drain.
NOTICE: Mastic à l'acrylique siliconée doit être utilisé pour sécuriser le lavabo au
meuble. Ne pas utiliser de mastic à la silicone à 100%, car cela endommagera la
finition du meuble.
Faire passer un boudin continu de mastic à l'acrylique siliconé de 1/4" (6 mm)
autour du dessus du meuble, tel qu'illustré.
ATTENTION: Risque de blessures corporelles. Les lavabos en porcelaine vitrifiée
sont très lourds. S'aider lors du levage et de l'alignement du lavabo.
1147372-2-C
12
Kohler Co.

Publicité

Table des Matières
loading

Table des Matières