System Configuration - Western WMarine10 Manuel De L'utilisateur

It displays the Energy counter in KWh consumed by the load. It is possible to reset this counter
pressing simultaneously the buttons
button Pressing the button you go back to the main page.

System configuration

You can go to the configuration pages of WMarine10 pressing simultaneously for at least 2 seconds the buttons
Charge program configuration page
....
Page change
Low Battery voltage configuration page
Page change
Exit low battery voltage configuration page
Page change
Load management program configuration page
Load always ON either
during day or during
night.
Page change
Page change
Tab.1 Display pages of measures
It sets the charge voltage for the battery.
SEAL must be set for sealed VRLA or GEL lead acid batteries (*).
FLOOD must be set for flood lead acid batteries (*).
Li must be set for charge lithium-ion batteries. In this case you must also configure the
exact charge voltage so that it is in accordance with charge voltage in the datasheet of the
battery manufacturer. In the WMarine10 you can set lithium-ion battery charge voltage in
the range:
14.0V – 14.7V for 12V systems,
28.0V – 29.4V for 24V systems
When lithium-ion program is activated, the charge voltage is not compensated in
accordance with temperature as in SEAL, FLOOD and programs, but the charge voltage is
equal for every temperature measured.
(*) Charge voltage relating to each one of the programs are indicated in the following
Pic.3, Tab.4 and must be chosen in accordance with the battery manufacturer indications.
It sets the intervention voltage of Low Battery protection (load detachment in case of low
battery). When pressing the button
12V systems and from 21.6V to 24.4V for 24V systems.
It sets exit low battery threshold voltage. With
the range from 12.4V to 13.8V for 12V systems, and from 24.8V to 27.6V for 24V systems.
Load ON only
Load ON only
during night.
during day.
Voltage detection day
WMarine10 detects the day when the voltage of PV module (Vpan) is > than the Vday
threshold; it detects the night when Vpan is < than Vnight threshold. In this page it is
possible to change Vday threshold. Vnight threshold = Vday – 0.8V
WMarine10
User manual
for 2 seconds.
you change the setting from 10.8V to 12.2V for
Load ON during
night for
hour.
6
button you will modify the threshold in
...
Load ON during night for
1
16 hours.
EN
.