Maintenance And Cleaning - Trebs Comfortshave 99227 Mode D'emploi

3. To insert a new outer foil, slightly bend the foil inward and place down until it
is parallel.
4. Hold firmly at both ends (1)(2) of the inner blades and pull upward to detach
the blades.
5. Hold both ends of the new inner blades and press downward until it snaps
into the shaver.

MAINTENANCE AND CLEANING

1. Regular clearing will keep the shaver in good condition and maintain its
cutting performance.
2. Unplug and turn the On/Off switch off. Remove the cover and detach the
outer foil hood.
3. Carefully clean the outer foil, inner blades and shaver body with a
cleaning brush.
Caution! NEVER clean the shaver with water.
SIMPLE CHECKING METHOD:
You should immediately stop using the shaver if it is malfunctioning. Before sending out for
repairs, you can do a simple checking based on the following checking table:
Type of malfunction
Blunt blade, weak rotation,
shorter shelf life
No indicator light unable
recharge
Service
If you have any further questions about the product after reading this manual, please
contact the Trebs customer service: Phone: 0900-TREBSbv (0900-873 27 28), € 0.30 per
minute.
CE
Part to examine
Check if there are too much
of beard residues
accumulated inside the inner
blades
Check if the On/Off switch is
turned off
Handing method
Clean regularly by using a
clearing brush or spray with
blade cleaner
Turn off the On/Off switch
and then try to recharge