Genie LA 500 A4 Guide D'utilisation page 9

11. The laminating machine is unsuitable for constant use commercially. It is
recommended to switch off the machine for 30 minutes, after it has been
operating for a period of approximately 30 minutes.
12. The socket should be near the device and easily accessible.
Description of machine components
A Insert opening
B Controller 80 micron/ ABS (OFF)/ 125 micron
ABS: Antiblocking system or jam release
C Power/ Ready
D Hot/ Cold
Hot laminating ('Hot')
1. Push the plug into the mains socket outlet and set the switch to 'Hot'. The
Power LED lights up and the heating process will begin.
2. The Ready LED lights up after approximately 5 minutes. Now you can begin
the laminating process.
3. Open the laminating film and lay the material that is to be laminated directly
onto the closed side. Leave a margin of between 3 mm and 5 mm
approximately beyond the edges while doing so.
9