UK
4. Always ensure that the sample chamber, the lid and the
stirring rod are thoroughly rinsed when changing from
one test to the other.
Warranty
The waterproof AquaInspektor is warranted to be free from
manufacturing defects for two years.
Operation
(see pictures)
1. Switch the unit on using the ON/OFF key. The display
shows: "0". Make one Zero for all the methods:
2. Swirl the instrument several times under the water
surface allowing the sample chamber to completely fill.
Take the instrument out of the water.
3. Close the lid tightly.
4. Press the ZERO/TEST key. "000" flashes for approx.
8 seconds. The display shows "0.0.0".
5. Pelect the test required using the MODE key:
Cl (free Chlorine/ total Chlorine) → pH → TA →
CyA → Cl ... (Scroll).
6. Open the lid and add the appropriate tablet straight
from the foil.
Method
ClF: Free chlorine (ClF)
ClT: Total chlorine (Clt)
pH: pH Value
CyA: Cyanuric acid
TA: Alkalinity-M
8
appropriate tablet
DPD No.1
DPD No.1 + DPD No.3
PHENOL RED PHOTOMETER
CyA-Test
ALKA-M-PHOTOMETER
7. Crush the tablet using a clean stirring rod. Stir until the
tablet is dissolved.
8. Close the lid and swirl the instrument gently for approx.
15 seconds.
9. Afterwards keep the instrument steady and wait for 15
seconds when testing ClF/pH/CyA and 2 minutes when
testing ClT and TA.
10. Press "Zero/Test". The "---" symbol flashes for approx.
6 seconds. The result appears in the display (mg/l). Or:
LOW
Result below lowest limit of measuring range
HIGH Measuring range exceeded
Repeat Test Press the "Zero/Test"-key
Change Method Take new sample.
Press the "Mode"- key to scroll down. Perform test.
New zero (Option)
Press the "Zero/Test"-key for 2 sec.
Conversion Table for water hardness
mmol/l K
= ^
1 mg/l CaCO
0.02
3
Important disposal instructions for batteries and
accumulators
EC Guideline 2006/66/EG requires users to return all
used and worn-out batteries and accumulators. They must
not be disposed of in normal domestic waste. Because our
products may include batteries and accumulators in the
delivery package our advice is as follows:
°dh
°e
°f
S4.3
0.056
0.07
0.10