Setup Guide - monolith THX 24456 Manuel De L'utilisateur

LFE & LINE UNBALANCED INPUTS: Use either of these RCA inputs to connect the LFE
output on your amplifier or receiver. If your amplifier/receiver does not have an LFE
output, connect the stereo preamplifier output on your amplifier/receiver to both
the 1 and 2 inputs.
XLR BALANCED INPUT: Use this XLR input to connect to a balanced audio source.
XLR DIRECT PASS-THRU: This XLR output passes the original audio signal without
modification of any kind.
FUSE/120 VAC: Plug the included AC power cord into the C14 panel connector on the
combined AC input and fuse holder. The fuse holder includes both the main fuse
and a replacement fuse. If you need an additional fuse, use the type indicated on
the rear panel.

SETUP GUIDE

To get the maximum performance from your new Monolith™ THX® Subwoofer, it must be
properly connected, positioned properly within the room, and configured to match your
main speakers. To connect the subwoofer you will need either a single mono RCA audio
cable (in the case of systems with a subwoofer/LFE output), a stereo RCA audio cable (in
the case of systems with a left/right pre-amp output), or an XLR cable (when connecting
from a receiver or processor with a balanced subwoofer output jack). Note that once an
input signal is detected on the RCA or XLR input, the subwoofer will select that signal
source and will disable the other source. To change the input from RCA to XLR or vice
versa, unplug the subwoofer from the power outlet.
10