Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Installation
1.
Connect the negative terminal of the battery to the negative connector of your caravan mover.
2.
Connect the positive terminal of the battery to the positive connector of your caravan mover.
3.
It is recommended to use a cable of at least 16 mm2. Use a red cable for the + and a black cable for the -. Always
follow the manual of your caravan mover when connecting the cabling.
Use
1.
The battery has more than enough capacity to carry out one manoeuvre of the caravan with a mover. It is
recommended to recharge the battery after each use for the next use.
2.
The battery is capable of delivering short, high currents to overcome a threshold or other obstacles. If this is
done for a longer period of time, the battery will turn off automatically and must reset itself.
3.
Unlike lead-acid batteries, it is possible to fully discharge this lithium battery with LiFePO4 technology. This
means 100% of the battery capacity can be used.
4.
When the battery is empty, it will turn itself off and must be charged before the next use. Charging takes place
via a charging cable and mains connection.
5.
Optionally available is a charger (car charger) that uses the car voltage to slowly charge the battery while driving.
With this, it is no longer necessary to install thick cabling.
6.
The battery can be securely mounted on a supporting structure by means of the bottom mounting.
7.
If you are not using the battery for a longer period of time, it is strongly recommended to disconnect the battery
terminals. Make sure that the battery does not run out because it is in standby mode. Also make sure that the
battery is not connected to the mains. If the temperature is below 0 ° C it should not be charged. The battery
can be stored this way for up to a year, due to its very low self-discharge.
How to charge the Powerpack
charging with an AC adapter
The battery can be charged by connecting the supplied connection cable to the power supply.
•
Connect the other end of the connection cable to the DC input port on the device. With the charging function
of the adapter input, the voltage range is 12V DC - 24V DC.
Correct disposal of this product.
This symbol indicates that this product must not be disposed of together with normal household waste
(2012/19/EU). To prevent possible harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote sustainable reuse of material resources. To return your used
device, please read the warranty terms from where the product was purchased. They can take the
product back for environmentally safe recycling.
Declaration of Conformity
Gimeg Nederland BV hereby declares that the device MPM-12-20-30 meets the basic requirements and other relevant
regulations mentioned in the European directive for electromagnetic compatibility (2014/30/EU) and the directive
relating to environmental EU Compliance (2015/863/EU). You can request a complete declaration of conformity at the
address stated on the back.
Publicité
