GERATHERM tensio control Mode D'emploi page 28

HOW TO OPERATURE THE DEVICE
1. Setting the Clock
Enter the clock setting mode by pressing and holding the MEMORY button for over
three seconds. The display will show a fl ashing year. Press the POWER button to
adjust the year when it is fl ashing. Then click the MEMORY button again, a „month„
will appear and fl ash to be adjusted, and then „date", „hour", and „minute" will follow as
you press and release the MEMORY button.
To adjust the clock:
Press the POWER button to adjust the „month", „date", „hour" and „minute" when they
are fl ashing.
GB
2. Measuring blood pres-
sure
Press and release the
POWER button to start
measuring automatically.
When the measurement
is fi nished, the display will
show the measured blood
pressure and pulse rate.
Press the POWER button
to turn off the device.
Otherwise the device will automatically turn off after 150 seconds.
Note:
If the symbol
measurement. If the symbol appears regularly please consult a qualifi ed physi-
cian for professional advice.
10 - GB
Initial
display
appears, it means the unit has detected irregular pulse during
Pumping Measuring and
buzzer sounds