Technical specifications AW 600:
The following technical data were measured on randomized test objects and are typical
data.
All measurements are made at 120V / 240V // 50Hz / 60Hz
Clipping point of the amplifier is set to a level where total harmonic distortion (THD) is 0.2 %.
Measurements
Input impedance
Input level for rated output (RMS)
Frequency response
Noise*
Output Impedance
Damping factor
Maximum peak current
THD
THD
* Noise is measured with input shorted.
Rated output power
10 % change in line voltage will give approximately 20 % change in output power.
8 ohm -
600 W
4 ohm -
1200 W
Power consumption
The AW 600 is DC coupled from input to output.
Dimensions
Width:
514 mm
Depth:
470 mm
Height:
288 mm
Weight:
41 kg
Specifications subject to change without notice.
Parameters
(Fixed)
(DC - 65 kHz)
(400 - 30 kHz)
(DC – 30 kHz)
(20 Hz - 20 kHz)
(20 Hz – 20 kHz)
(1 kHz, half power, 8ohm) < 0,001 %
(1 kHz, -1 dB, 8 ohm)
230 W
no load or signal
-
20.2 "
-
18.5 "
-
11.3 "
-
90.2 lbs.
4
Balanced
55 kohm
1 V
-0.4 dB
< 150 µV
< 200 µV
< 0,009 ohm
> 900 X
> 150 A
< 0,0015 %
USA
GB