Installation; Power Supply; Connect The Base Unit To The Telephone Line; Fitting Batteries - BRONDI BRAVO CORDLESS 2 Manuel D'instruction

IMPORTANT!
The mains power lead must be installed near the equipment and must be easily accessible.
1. Plug the mains adapter pin end into the base unit power plug.
2. Plug the mains adapter into the wall mains socket.
1. Insert the telephone line plug into the base unit socket.
2. Insert the telephone line threefold plug into the wall telephone socket.
1. Place your handset with the keypad facing downwards.
2. Remove the battery compartment cover by pushing and pulling it in your direction
3. Insert the two batteries (AAA) into the battery compartment, paying attention to the polarity
orientation.
4. Slide the battery compartment cover back into place, pressing fi rmly to make sure it is
sercure.
IMPORTANT!
TO CHARGE THE BATTERIES FULLY BEFORE YOU USE THE CORDLESS HANDSET FOR THE FIRST TIME
LEAVE THE HANDSET ON THE CHARGER POD FOR 15 HOURS.
When your handset is discharged the Low Battery symbol appears on the display. To recharge
it, just replace the handset on the charger pod with the keypad in your direction.
To recharge the batteries fully leave the handset on the charger pod for 15 hours.
IMPORTANT: Only use the rechargeable batteries provided for this model.
When the handset autonomy starts reducing, even when batteries are correctly recharged, it is
time to replace the batteries: follow the instructions in Paragraph "5.3 Fitting Batteries".
BRAVO CORDLESS-2-lingue
5. I
NSTALLATION

5.1 POWER SUPPLY

5.2 CONNECT THE BASE UNIT TO THE TELEPHONE LINE

DC 9V
MAINS POWER LEAD

5.3 FITTING BATTERIES

5.4 RECHARGING YOUR CORDLESS

5.5 REPLACING BATTERIES

10
TEL LINE
TELEPHONE LINE CORD
10
6-09-2005, 16:02