Publicité
Les langues disponibles
Les langues disponibles
PRX-4A
Power for Receiver
Using the PRX for the fi rst time
At this point we assume that you have read and absorbed the complete operating instructions,
especially in respect of special notes, characteristics, voltage ranges and battery types.
In the following section we assume that your system incorporates
suitable batteries, and that they are fully charged.
WARNING
When
selecting
capacity
and
quality,
nected to the unit.
1.
Solder a battery connector suitable for your battery to the
2.
Attach the PRX e.g. with double sided tape at an appropriate spot in the model. The PRX deve-
loped a degree of heat, if possible, choose a location where the air can circulate.
3.
Connect the
RX plug of the PRX to the battery socket of your receiver.
4.
Connect to a suitable battery to the
5.
If necessary, you can use a switch between the battery and the PRX. However, we recommend to
connect the battery directly to the PRX, to exclude the source of error of a switch.
BAT
your
batteries
it
depending
BAT input of the PRX.
is
essential
to
on
the
number
BAT input of the PRX.
8
choose
types
of
and
type
of
servos
suitable
con-
RX
Publicité
