Bellman & Symfon BE1510 Mode D'emploi page 35

68
Settings
No adjustments are required for normal use. The relevant descriptions are provided below, if you
wish to change a setting for some reason.
Radio key
In order to use several Bellman Visit 868 Systems close to one another without interference,
different Radio Keys can be set on the different systems. All Bellman Visit 868 System units are
supplied from the factory tuned to the same Radio Key, channel 0. This means that all Radio Key
Switches on the transmitters are set to the OFF position.
• To alter the Radio Key, move the Radio Key Switches (5) to the desired positions.
Please note: all Bellman Visit 868 products within a system must be tuned to the same Radio Key in
order to operate as a group.
Signal pattern
A Signal Pattern is the name for the way in which a receiver in the Bellman Visit 868 System
indicates activation. Changing the transmitters' Signal Switch changes the Signal Pattern which the
receivers display when the transmitter is activated. Follow the instructions under Appendix/Further
information/Settings/Setting the activation pattern to make your choice.
The following signal patterns are available for the Bellman Visit 868 Repeater:
Type LED pattern Sound
Green 1 Green is 1 x ding dong,
constantly lit low-frequency
tone
Green 2 Green blinks in 2 x ding dong,
sequences of two low-frequency
tone
Green 3 Green blinks 1 x ding dong,
in sequences of high-frequency
three tone
Green 4 Green blinks 2 x ding dong,
constantly high-frequency
tone
Yellow 1 Yellow is 1 x ring, low-
constantly lit frequency tone
Yellow 4 Yellow blinks 2 x ring ring,
constantly high-frequency
tone
Orange 1 Orange is Baby
constantly lit
More information about the signal patterns follow on the next side
69
Vibration Flash
CZ
Separate Yes
DE
DK
Separate Yes
ES
FI
Separate Yes
FR
GB
Separate Yes
GR
HU
IT
Short Yes
NL
Short Yes
NO
PL
Rapid Yes
PT
SE
YU