Bellman & Symfon BE1510 Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
28
Indicators and Signals
System indicators
The LED (1) blinks, when the Bellman Visit 868 Repeater transmits or receives radio signals.
Power supply
When the Repeater is connected to the power supply unit, the LED is constantly green, apart from
when it is receiving or transmitting radio signals when it blinks.
When the Repeater is activated, the LED (1) lights up green. This means that the back-up battery is
in good condition.
If the LED (1) blinks yellow, this means that the back-up battery is flat and must be changed. Only
use a 6LR61 (alkaline) or 6F22 (lithium) type battery.
Troubleshooting in brief
Problem
Nothing happens when the transmitter is activated
with the Test Button (2).
Solution
• Check that the power supply unit is connected
correctly.
• If the power supply unit is not connected, change
the back-up battery. Only use an alkaline 6LR61 or a
lithium 6F22 type battery.
Make sure that the power supply unit is connected
correctly.
The LED (1) blinks yellow when the Repeater is
activated.
The LED (1) blinks green when the Repeater is
activated, but the receivers are not signalling.
The receivers in the system transmit signals for no
reason.
For further information about the product in English, refer to the Appendix.
1. LED. Combined transmission and back-up battery indicator. For
further information see Indicators and Signals
2. Test button/pushbutton
3. Exterior External Trigger.
4. Signal switch
5. Radio key switch
6. Connector for power supply unit
7. Battery cover
8. Wall mount bracket
• Change the back-up battery. Only use an alkaline
6LR61 or a lithium 6F22 type battery.
Make sure that the power supply unit is connected
correctly.
• Check the battery in the receiver.
• Check that the receivers are not placed too far
away by moving them closer to the transmitter.
• Check that the Repeater is set to the correct radio
key. For further information see Function/Radio
key.
• Change the Radio Key on all units in the system.
For further information see Function/Radio key
29
CZ
DE
DK
ES
FI
FR
GB
GR
HU
IT
NL
NO
PL
PT
SE
YU

Publicité

Table des Matières
loading

Table des Matières