Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation and Operation
The following steps are for an installation using the C6 HDMI Transmitter with display
equipment with integrated HDBaseT Technology and a HDMI source. If you are using DVI
equipment, please substitute the HDMI cables for DVI to HDMI cables where required.
1.
Connect your HDMI source to the C6 HDMI Transmitter unit using a HDMI cable
(maximum length 5m).
2.
Connect one end of the Cat.5e/6/7 cable (max. length 100m) to the output port
on the C6 HDMI Transmitter and the other end to the HDBaseT port of HDBaseT
equipped Display/Projector. Use solid core installation cable of at least Cat.5e
UTP.
3.
For Ethernet functionality, connect your devices to the 10/100Base-T ports on the
Transmitter.
4.
Plug the DC power supplies into the Transmitter and display equipment with
integrated HDBaseT Technology and switch on.
5.
Power on your HDMI Source to complete the installation.
For further information, including troubleshooting tips please refer to the manual for the
HDBaseT
Splitter Series of
www.LINDY.com.
Only use a direct Cat.5e/6/7 cable connection between the HDBaseT ports. Do not
connect these ports to Network or Ethernet equipment or any active components
products (LINDY No.
!!! IMPORTANT !!!
English
38116-8) available from
Publicité
Table des Matières
