Inakustik PREMIUM DLNA Mode D'emploi page 10

USER MANUAL
6.0 CONNECT TO THE ADAPTER OVER WLAN NETWORK
When the adapter is initially powered up, the default setting is the AP mode.
1. Using the WLAN setting procedures of your smart device to search the WLAN APs (by its SSID), just like
you want to connect to other WLAN APs.
2. Find the in-akustik_DLNA_V01 SSID and Connect to it.
3. After a while, your smart device should indicate it has been connected to the adapter.
Tips: The default security setting of the adapter AP is open mode, it is not a save mode, other smart device
around you might be able to connect it if the signal strength is strong enough for them.
It is strongly reminded that you have to setup a more secure encryption of the AP, such as WPA2 mode. To
setup to this mode, please refer to the section below.
NOTES
: the password might be varied according to your later on setting.
You can do some WLAN setting to the adapter:
1. Change the security setting;
2. Change from AP to client mode;
3. Change from client to AP mode.
All the setting to the adapter device should be done over a Webpage browser installed in your smart device.
Your smart device must be directly or indirectly connected to the adapter over WLAN network. The following
procedures instruct how to do that:
1. Change the security setting of AP:
1.1 Make sure your smart device has been WiFi connected to the AP of
1.2 Input the IP address (Shown on the TV screen) to
1.3 Your smart device should show a connection status page like this:
10
1.4 In the AP setting section, set a preferred SSID.
1.5 Select the encryption mode of WiFi, we recommend using WPA2 mode.
1.6 input and confirm the password.
1.7 Select OK to confirm all settings.
1.8 The AP of the adapter device is WPA2 protected now.
WARNING
the password be forgot, it can't be set back!
the adapter.
the webpage browser on your smart device to access the setting page of
the adapter.
:
Please do write down the password and place the record to a secure place. Should