Faust EX 125 E-01 Instructions De Service page 7

Anleitung EX 125 E-01 Ostspr.
Switching on and off
To switch on: Press On/Off switch A.
To operate: Secure switch A with the lock button B.
To switch off: Press On/Off switch A.
The machine can be operated either intermittently or continuously.
Speed regulation / speed selection
To regulate the speed, apply more or less pressure to the switch A.
You can select the speed in advance by turning the knurled screw C in the
switch A.
Important!
Wear goggles and a dust mask.
Keep the cooling vents on the motor housing clean and
unobstructed at all times.
To be able to make the best use of the eccentric sander,
always use original spare parts and accessories,
available from all specialist retailers.
Fitting the sanding disk
Easy disc replacement thanks to Velcro-type backing. Make sure the
apertures in the disk coincide with those in the backing pad.
Replacing the backing pad
Release the 4 screws and then remove and replace the backing pad.
Important!
Damaged backing pads must be replaced immediately. Always
remove the plug from the socket first.
Working with the eccentric sander
The entire sanding surface must rest on the workpiece.
Switch on the machine and, applying moderate pressure, move it
over the workpiece in circular, crosswise or lengthwise
movements.
Use a coarse-grained disk for rough sanding and a fine-grained
disk for fine sanding. The best grain for a particular job is best
ascertained by trial runs.
Important!
Wear a dust mask and goggles. Protective gloves are
recommended. The sander must never be used for work on
materials which contain asbestos.
06.11.2001 11:09 Uhr Seite 7
B
A
GB
C
7