Setting The Clock - Bigben MCD11 Mode D'emploi

Power
• Risk of product damager! Make sure that the power voltage corresponds to the
voltage printed on the back label.
• Risk of electric shock! When you unplug the AC power cord always pull the plug
from the socket. Never pull the cord.
CAUTION
• Before connecting the AC power cord, ensure you have completed all other
connections.
Auto standby
When no music play from a connected device, the product automatically switches to standby if:
• No button is pressed for 10 minutes,
• No audio from a connected device for 10 minutes.
Speaker connection
Unfurl the loudspeaker wires and connect them to the corresponding terminals.
Power supply by AC adaptor
1. Connect the AC/DC adaptor to the DC JACK of the unit.
2. Connect the AC/DC adaptor to a properly installed wall socket (AC 230V/50Hz).
Note:
Unplug the adaptor from the mains and the unit when the unit is not in use for a prolonged period of
time.
Adapter shall be installed near the equipment and shall be easily accessible.
Battery power
Be sure that the batteries are inserted correctly to avoid damage to the appliance. Always remove the
batteries when appliance will not be used for a long period of time, as this will cause leakage to the
batteries and subsequently damage to your set.
Do not ingest the battery. Chemical Burn Hazard. This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead
to death. Keep new and used batteries away from children. If the battery compartment does not close
securely, stop using the product and keep it away from children. If you think batteries might have been
swallowed or placed inside any part of the body, seek immediate medical attention.
Standby Function
Switch power to standby to save energy
1. Press and hold the
and this indicates that the unit is in standby mode.
2. To avoid unnecessary energy consumption always set the unit to standby mode.
Operation
1. Select your sound source by pressing the
2. Adjust the sound by VOL knob.
3. Switch off the set by pressing and holding the

Setting the clock

Power off (in standby mode)
1. Press and hold the
2. Press the or
3. Press the
4. Press the or
5. Press the
button for 3 seconds to turn off the Unit. The display will show the clock
BUTTON for 3 seconds and the hour will begin to flash.
button to adjust the hour.
BUTTON to confirm and the minute will begin to flash.
button to adjust the minute.
BUTTON to confirm.
button.
button for 3 seconds.
- EN 4 -