Cleaning & Maintenance - Alpine SF-9371 Mode D'emploi

ENGLISH
1.
Fix the heater with the bracket that provided using the 4pcs of M6*10mm Screws and knobs.
2.
Fix the bracket on the wall by using the 4PCS M6*50mm, screw it tightly.
3.
Adjust the reflector in the required beam direction. This will be a declination of about 30°-45° horizontally. Tighten the knobs on
end caps once direction has been fixed.
HOW TO USE
1. The Pull-Off Switch is used to control the power of the appliance.
2. Once the power is on, the Pressing Switch on the heater is used to control the heat setting. (I) for1500W, the 0 position is off.
3. The Remote control is also used to control the two heat settings. (I) for1500W, the 0 position is off.
4. Although the patio heater is shower proof, do not use when raining or in wet conditions.
5. Always disconnect the power cable from the electrical supply, when the patio heater is not in use.
Warning:
This appliance is equipped with a grounded, Type G, 3-pin power supply cord. This is a safety feature. Do not attempt to defeat the
safety purpose of this plug.
CLEANING & MAINTENANCE
1. Unplug the unit and let it cool completely.
2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary.
After cleaning, dry the unit with a soft cloth.
3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage
or deterioration to the surface of the heater.
4. Although this heater is outdoor approved, DO NOT immerse the heater in water for your safety.
5. If the heater will not be used for a long period of time, store it in a cool, dry place, to prevent dust and dirt build-up, use the
original packaging to repack the unit.
3