Radio Operation - Brandt BCR115PB Notice D'utilisation

RADIO OPERATION

1. Press POWER/MODE to turn on the radio.
 The default FM radio frequency is 87.5 MHz.
2. Repeatedly press POWER/MODE to select the radio frequency AM or FM.
 The corresponding indicator lights ("AM" and "KHz" or "FM" and "MHz") will illuminate.
3. Adjust the volume by repeatedly pressing VOL-/AL1 or VOL+/AL2.
4. Repeatedly press TUN/+ or TUN/- to tune into the desired station.
 Press and hold TUN/+ or TUN/- for auto forward or backward radio station searching.
NOTE:
 For the best FM reception, extend the FM aerial to its full length.
 For the best AM reception, rotate the unit slowly and horizontally.
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 20 FM and 20 AM radio stations can be preset.
1. Follow steps in "RADIO OPERATION" and tune in to the station that you wish to preset.
2. Press MENU, "P01" will flash on the display.
3. Repeatedly press TUN/+ or TUN/- to select the desired memory slot.
4. Press MENU again to store the station.
5. Repeat steps above to store desired stations.
To listen to preset radio stations, repeatedly press PRESET to select the desired radio station.
DUAL ALARMS OPERATION
Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 or Alarm 2
1. In standby state, press and hold VOL-/AL1 or VOL+/AL2 for 2 seconds.
 "bU" will flash.
2. Repeatedly press TUN/+ or TUN/- while "bU" is flashing to select the wake-up mode (Buzzer, AM or
FM radio).
3. Press VOL-/AL1 or VOL+/AL2 to confirm.
 The hour digits will flash.
4. While the hour digits are flashing, set the hours by repeatedly pressing TUN/+ or TUN/-.
5. Press VOL-/AL1 or VOL+/AL2 to confirm.
 The minute digits will flash.
6. While the minute digits are flashing, set the minutes by repeatedly pressing TUN/+ or TUN/-.
7. Press VOL-/AL1 or VOL+/AL2 to confirm.
-
EN 4