Battery Backup; Standby State; Setting The Clock - Brandt BCR115PB Notice D'utilisation

DISPLAY
Indicator light
No battery backup
ALARM1 Alarm 1 activated
ALARM 2 Alarm 2 activated
SLEEP Sleep timer

BATTERY BACKUP

The clock and alarm settings can be protected against AC power failure with the batteries for a short
period of time. If no backup batteries are installed or the power failure is prolonged, you will need to set
the clock again.

STANDBY STATE

Place the unit on a flat stable surface and plug the power adapter into the mains socket.
 The "OFF" indicator light will illuminate, indicating the unit is in standby state. "0:00" will flash on
the display.
 If no batteries are installed in the unit, the battery icon

SETTING THE CLOCK

1. In standby state, press and hold TIME until only the hour digits flashes.
2. Repeatedly press TUN/+ or TUN/- to set the hours.
3. Press TIME to confirm. The minute digits will flash.
4. Repeatedly press TUN/+ or TUN/- to set the minutes.
5. Press TIME to confirm.
 The hour and minute digits will stop flashing.
POWER ON/RADIO MODE
Press POWER/MODE to switch the unit on and enters the raido mode.
 The radio frequency will briefly appear on the display and then return to clock time.
 The "ON" indicator light will illuminate.
SNOOZE Turn off the alarm temporarily
ON, OFF Power on or standby
FM, AM Radio frequency
KHz, MHz Radio frequency units
will flash on the display.
-
EN 3