Maintenance And Service; Maintenance And Cleaning; Declaration Of Conformity - stayer S110PE Instructions D'emploi

• Set the I/O laser switch (16) to the position I to activate the
laser guide (14).
• Press the On/Off switch (2), and start cutting the
workpiece following the predrawn linewith the projected
laser line on the surface.
Metal cutting
When sawing metal, because of the heating up of the
material, apply e.g. a cool lubricant along the cutline.
• Lightly grease the cut-line with suitable oil.

Maintenance and Service

Maintenance and Cleaning

- Before any work on the machine itself, pull the mains
plug.
- For safe and proper working, always keep the
machine and ventilation slots clean.
Clean the saw blade holder regularly. For this, remove the
saw blade from the machine and lightly tap out the machine
on a level surface.
Heavy contamination of the machine can lead to
malfunctions. Therefore, do not saw materials that produce
a lot of dust from below or overhead.
- In extreme working conditions, conductive dust can
accumulate in the interior of the machine when
working with metal. The protective insulation of the
machine can be degraded. The use of a stationary
extraction system is recommended in such cases as
well as frequently blowing out the ventilation slots
and installing a residual current device (RCD).
Lubricate the guide roller (10) occasionally with a drop of oil.
Check the guide roller (10) regularly. If worn, it must be
replaced through an authorised Stayer after-sales service
agent.
WARNING! Important instructions for connecting a
new 3-pin plug to the 2-wire cable. The wires in the
cable are coloured according to the following code:
Do not connect the blue or brown wire to the earth terminal
of the plug.
Important: If for any reason the moulded plug is removed
from the cable of this power tool, it must be disposed of
safely.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for Stayer
power tools.
ENGLISH
16
Repair service of the manufacturer or
commercial agent
Stayer Ibérica S.A. Área Empresarial de Andalucía - Sector
1, Calle Sierra de Cazorla No. 7. Postal code: 28320 Pinto
(Madrid) Spain.
Disposal
It is compulsory to subject electric tools,
accessories and packaging to a recovery
process that respect the environment.
For EU countries only:
Do not throw away electric tools!
In accordance with European Directive 2002/96/EC on
unserviceable electric and electronic apparatus, after its
transposition into national law, they must be collected
separately to subject them to ecologic recycling.
The right to amendment is reserved.

Declaration of Conformity

The undersigned:
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +34 902 91 86 81 / Fax: +34 91 691 91 72
CERTIFIES
That the machine:
Type:
Jigsaw
Models:
S110PE/S110PEK/S111PEK
JS80PE/JS55BE
We declare under our sole responsibility that the product
described under "Technical Data" is in conformity with the
following standards or standardization documents: EN
60745 accord-ing to the provisions of the directives
2006/42/EC, 2004/108/EC, 2006/95/EC
16
STAYER IBERICA, S.A.
Ramiro de la Fuente
Director Manager