LEGRAND Wattstopper EORS-101 Mode D'emploi page 3

For EORS-101 or EOHR-101 tap button 3 times
For EORS-102 or EOHR-102 tap the desired button 3 times to pair that button to the load that is ON. Once paired the switch will exit
pairing mode. Repeat steps 1 through 3 to pair the next button.
NOTE: If only one button is to be paired to 1 load, only press the desired button 3 times. The selected load(s) status LED on the
receiver will flash OFF/ON for visual pairing confirmation.
You can have a load bound to one button, both buttons or no buttons.
Step 4 Exit "Pairing" Mode on Receiver
Once a device is paired with the receiver the receiver will automatically exit "pairing" mode.
• To manually exit pairing mode, press and hold the "Pairing" button "P" on the receiver until the blue LED turns off, approximately 3
seconds.
• The device will also exit pairing mode if no device is paired to it within 30 seconds.
If using single button remote EORS-101 or EOHR-101
Press and hold the Paring Mode button "P" for approximately three seconds then release. The Green LED
will start flashing confirming you are in Pairing mode. The load will turn ON if previously OFF.
• Tap the remote button 3 times to unpair the remote from the reciever switch.
• The load will temporarily turn OFF and ON confirming the message was received.
• The green Pairing LED on the switch will stop flashing and exit pairing mode.
• The remote button should no longer control the load.
• Repeat steps above to unpair additional remotes.
If using a two button remote EORS-102 or EOHR-102
* It is recommended that you first confirm how the buttons are paired to the receiver switch. Using the
remote, press each button to turn the loads ON and OFF in order to see which button is paired to each
load.*
• Press and hold the Paring Mode Button "P" for approximately three seconds then release. The
Green pairing "P" LED will start flashing confirming you are in Pairing mode. The loads will turn ON if
previously OFF.
Using the "Pairing" Button "P" on the Receiver, select the load(s) to unpair
• Pressing the Pairing button "P" once will turn Load 2 OFF and Load 1 will remain ON.
• Pressing the Pairing button "P" again will turn Load 1 OFF and Load 2 will turn ON.
• Pressing the Pairing button "P" again will turn both loads ON.
• Use this method to select which load or loads to unpair.
EORS-101 Series
EORS-102 Series
UNPAIRING REMOTE BUTTONS FROM A RECEIVER (SWITCH)
EOHR-101 Series
legrand legrand
EOHR-102 Series
3
EOSW-101
"Load Status"
Blue LED
Pairing
Button
EOSW-102
"Load 1 Status"
Blue LED ON
Pairing
Button