LEGRAND Wattstopper EORS-101 Mode D'emploi page 2

The EORS-10x Wireless Remote Switch and
EORS-10x Handheld Remote are self-powered by
harvesting the kinetic impulse of the physical push of
the button.
Once a device is paired with the remote, the EORS
and EOHR use radio frequencies to transmit
signals to the wireless system. To turn load(s) ON/
OFF, press the paddle button on the EORS-10x or
EOHR-10x.
PAIRING OF REMOTE SWITCH TO WALL SWITCH RECEIVER LOAD(S)
Pairing of the remote switch or handheld remote is simply done by entering pairing mode at the wall switch receiver (EOSW-1x1 or
EOSW-1x2) and pressing the Pairing button "P" on each device for 3 seconds.
Step 1 Enter Pairing Mode
Press and Hold "Pairing" Button "P" on Receiver for 3 Seconds then release:
• Pairing LED on the EOSW switch begins to blink rapidly (2x/second). This confirms that the Receiver is now in pairing mode. For
EOSW-101/ EOSW-111
• Load 1 turns ON and is ready to be paired
• Load status button LED is Solid ON. For EOSW-102/ EOSW-112
• Load 1 & 2 turn ON and are ready to be paired
• Load status button 1 & 2 LED are Solid ON
Step 2 Selecting a Specific Load to Pair (EOSW-102)
*By default, both loads turn ON at the same time in Pairing Mode. If both loads are to be controlled by the Remote Switch than skip this step.
Tap the "Pairing" Button "P" once while in pairing mode:
• Load 2 turns OFF and Load 1remains ON
• Load 1 is now active and ready to be paired to selected transmitters
• Load 1 LED is Solid ON
Tap the "Pairing" Button "P" once again while in pairing mode:
• Load 1 turns OFF and Load 2 turns ON
• Load 2 is now active and ready to be paired to selected transmitters
• Load 2 LED is Solid ON
Tap the "Pairing" Button "P" a third time while in pairing mode:
• Load 1 and Load 2 turn ON again, indicating both loads are ready to be paired.
Step 3 Pair Remote Switch (EORS or EOHR) to Receiver
Tap the button on the Remote Switch or Handheld Remote as follows:
POWER AND OPERATION
EOSW-101
"Load Status"
Blue LED
Pairing
Button
EOSW-102
"Load 1 Status"
Blue LED ON
Pairing
Button
EORS-101
EORS-102
On/Off
On/Off
button(s)
button
Press on top of button Press on the top left
to turn load On and or top right button to
press on bottom of turn load On
button to turn load Off Press on the bottom left
or bottom right button to
turn load Off
2
EOHR-101
On/Off
button
Press on top of button
to turn load On and
press on bottom of
button to turn load Off
EOSW-102
"Load Status"
Blue LED
Pairing
Button
EOSW-102
"Load 1 Status"
Blue LED OFF
Pairing
Button
"Load 2 Status"
Blue LED On
EOHR-102
On/Off
button(s)
Press on the top left
or top right button to
turn load On
Press on the bottom left
or bottom right button to
turn load Off