Rane RAD22 Guide D'utilisation page 4

Example
Mic/Computer/RAD22 audio output
Amp output to speakers
Signal to multiprocessor
Installation
To install the RAD22 in a 2-gang electrical box:
Step 1:
•
Install the electrical back box into the surface of the desired location for the RAD22.
•
Run the shielded Cat 5e cable or better from a Rane multiprocessor (e.g. Terminal
1010X, HAL3s, etc.) to the inside of the back box.
•
Once the back box is installed and secured, secure the metal mounting bracket to
the back box using the provided screws.
Step 2:
•
Make the RJ-45 RAD connection to the port on the rear panel of the RAD22.
•
Connect the other end of the shielded Cat 5e cable or better to the Rane
multiprocessor
communications to the RAD22.
•
Attach the RAD22 frame to the mounting bracket by hooking the top of the frame
onto the extended lips at the top and bottom of the bracket.
Step 3:
•
Use a screwdriver to secure the RAD22 to the bottom of the mounting bracket using
the provided screw. Be careful not to over-tighten the screw.
•
Your RAD22 is now installed!
4
Microphone
REMOTE AUDIO DEVICES & DRs
4 3
Multiprocessor
RAD (remote audio
Computer
2 1
device) port
Speaker
Speaker
RAD22
Amp
to supply power and