nVent RAYCHEM FROSTEX Mode D'emploi page 5

Step 2.
Install the end seal
Note: The end seal can only be used once,
so do not install it until step 2D.
Heating Cable Construction
2A. Prepare the heating cable
Cleanly cut off one end of the heating cable.
2B. Push the braid back
Push the braid back 1 in (25 mm) from
heating cable end.
2C. Remove the plastic wrap
Cut and remove the clear plastic wrap. Do not
cut into the blue jacket.
Clear plastic
Braid
1 in
(25 mm)
1 in
(25 mm)
wrap (bus wires inside)
2D. Install the end seal
Firmly push the end seal at least 3/4 in (2 cm)
onto the heating cable. Some gel may ooze out.
2E. Secure the braid
Slide the braid back up against the end seal.
Black core
Blue jacket
nVent.com/RAYCHEM
|
5