Clean Air Optima CA-704 Smart Mode D'emploi page 7

Humidity sliding setting Button
(Only for MODE program: Normal dehumidification)
By pressing the Humidity sliding setting Button, you can select the desired humidity
level by pressing and sliding this button repeatedly until the required humidity level
is displayed (from 30% to 80% in increments of 5%). Once you select your desired
humidity level, simply stop pressing and sliding the button and your humidity level
will be set. When the humidity level in the room reaches the set humidity level, the
device will go into automatic sleep state and stops dehumidifying and air purifying.
When the room's actual humidity level increases again above your set humidity level,
then the device will start dehumidifying and air purifying again.
Air purification
If the desired humidity level is reached at a constant level, you can switch to program
3 to use the device for continuous air purification.
Fan Speed
(Only for MODE program: Normal dehumidification and Continuous air purification)
By pressing the Fan Speed Button, you can change the fan speed level. The 2 fan
speeds offer individual air flow.
Negative Ion, icon with name in App: Ion
Pressing the Negative Ion Button will activate the negative ion generator with a total
capacity of > 3.000.000 negative ions / cm² that are spread through out the entire
room and thereby neutralize pollutants and smells. Negative ions attach onto dust
particles, microorganisms and other unwanted particles in the air and connect them
to each other. This way, the particles become heavier than air and fall onto the
ground so that you can no longer breathe them in.
Negative ions are most found in the forest, mountains and by the sea.
Negative ions ensures fresh and healthy air.
Timer
Press the Timer Button to set 0-24 hours timing. Press the button one time, the
timer will increase with one hour. When the device is operating, the timer that is set
indicates when the device switches off. If the device is in stand-by mode, the timer
that is set is to instruct the device when to turn on.
Sleep
Press the Sleep Button and the sleep mode is activated, the display will turn of in ca.
3 seconds. Press the Sleep Button 2x rapidly to switch back again in the settings
before.
Water Tank Full Indicator Light
When the water tank is full, the device will stop automatically. The Water Tank Full
Indicator Light turns on and lights up. Drain the water tank, and return the water tank
to the body of the device, the Water Tank Full Indicator Light will turn off. The device
will work automatically again.
7