Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
CONNECT THE LOUDSPEAKERS
Use in Stereo mode:
The A2700 amplifier is designed to drive a pair of loudspeaker with 4 or 8 Ω impedance.
The amplifier terminals can accept bare cables, cables with forks, or with male banana plugs:
Bare cables: strip approximately 10 mm of
the cable and carefully twist the conductor
strands. Unscrew the terminal block until
the hole appears, insert the stripped part
of the cable. Screw the terminal block
back on firmly by hand.
Always make sure to respect the polarity + (red) & - (black) between your loudspeakers and the
device and that these two polarities are not in contact to avoid causing any short-circuit.
36
Forks: unscrew the terminal block until each
fork can be inserted. Check that they are
well parallel and screw the terminal block
firmly by hand.
Banana plugs: insert the male banana
plug in the center of the terminal block to
its maximum.
Publicité
Chapitres
Table des Matières
